 |
1. Power source assembly
Method 1. Connect the power to single-phase 220V/60HZ fuseless switch.
Method 2. Use single-phase 220V/60HZ connector and socket. |
2. Water source assembly (Method 1)
Use 1/2" or 3/4" PVC hose and drill a 7 mm hole with electric driller.
Unscrew the water inflow valve screws.
Insert the inflow valve inlet into the hole on PVC hose and then lighten up the screws.
Insert the 1/4" soft black plastic hose into the water inflow valve, and insert the other end to the venting machine.
Turn on the inflow valve switch (to see the round hose is turning on) to allow the water flow in. |
|
3. Water source assembly (Method 2)
(1)Dismount the faucet and connect to the vertical board that has drilled a 7mm hole.
(2)Connect 1/2" hose connector.
(3)Then mount the faucet back.
|
|
(4)Unscrew the inflow valve screw.
(5)Insert the 1/2" inflow valve inlet into the drilled hole on the vertical board and then lighten up the screws.
(6)Insert the 1/4" soft black plastic hose into the water inflow valve, and insert the other end to the venting machine.
(7)Turn on the inflow valve switch (to see the round hole is turning on) to allow the water flow in. |
|
