|
1.Shut up the water inflow switch. Take out the fender screws.
2.Push the fender upward so as to take down the fender. |
|
|
7.Press the water collecting board downward.
8.Pull the exchange board backward from the bottom to take out.(Do the same to take out the two boards at the middle). |
|
|
|
|
3.Pull the xxxv shape handle backward.
4.Pull the exchange board upward to take it out. (Do the same to take out the two boards at the middle). |
|
|
9.Pull the bottom of the exchange board to the right to take it out.
10.Pull the bottom of the exchange board to the left to take it out. |
|
|
|
|
5.Pull the bottom of the
exchange board to the right
to take it out .
6.Pull the bottom of the
exchange board to the left
to take it out.
|
|
|
11.Use fine iron wire to get through PVC sprinkle pipe to clean the foreign objects inside the jammed water holes.
12.Clean the water tank and exchange board with clean water, and than put all the dismounted items back in reverse order.
|
|
Cautions :
-
Please use clean water with appropriate pressure to flush and clean the exchange board. Detergent is absolute not allowed. (The detergent is uneasy to clean and will left on the exchange board and make bubbles, which will cause the splash of water at the air outlet).
-
The PVC sprinkle pipe to be bended after pressed with force, it can be taken down from the fixed bracket for cleaning. Pay attention to check if the connection is screwed tight when mounting back.
-
The hole gaps in front sprinkle pipe is wider, so the sprinkle hole is inclined backward in
45°.
-
The hole gaps in rear sprinkle pipe is narrower, so the sprinkle hole is inclined backward in
90°.
|
|
